1. Open type mechanical press is used for the production of gantry high-speed punch large and small parts, bending parts, drawing parts and cleaning parts.

2. The mechanical press with closed structure is used to produce small and medium-sized metal stamping parts.

3. Small batch production, hydraulic press for the production of large and medium-sized thick steel plate metal stamping parts.

4. At the beginning of mass production or mass production of complex parts, select high speed working pressure machinery and equipment and multi-process automatic press.

Second, the specifications and models are based on the high-speed gantry punch punching machine parts of the punching mold specifications and mold specifications and the punching pressure to clear.

1. According to the standard of the press, the working pressure should exceed the total working pressure of the stamping die required by the stamping die.

2. The travel arrangement of the press should be matched. The travel arrangement immediately endangers the main height of the mould.

3. The closing and closing height of the press should match the closing and closing height of the mold. In other words, the closing and closing height of the precision high-speed punch mold can only be between the larger of the press and the minimum closing and closing height.

4. The specifications of the operation table of the high speed fine high-speed punch machine should exceed the overall specifications of the mold base. There should be fixed indoor space for installation, but the operation table can not be large.

In the actual operation of sheet metal laser processing, there are some problems in the high speed fine speed punch, which should be dealt with according to the more serious level of the fault or whether it can be handled quickly. To leave to the high-speed punch machine equipment on the "difficult disease" to make a relative solution, this countermeasure must comply with the following strategic policy, completely solve the problems.

In case of failure, be sure to turn off the power immediately. After inspection, detection and analysis, CNC machine tool completely stopped running. Only when it is clear that the failure is not repeated or leads to a devastating blow to the equipment itself can the stamping machine be plugged in again. After the operation again, the operator is required to carefully observe and check the operation status, and finally find the direct cause of the failure.