High speed, fine and high speed punch guide pillar is the precise guide equipment for the relative speed of the left and right dies of tubular parts. Most of them cooperate with the positioning pin fixed on the upper die seat and the upper die seat. Be sure to make sure that the punch and die point, correctly guide and unload (parts), so that the plate parts in the punch accurately drag and cooperate with each other. The positioning pin is a cylindrical part, which provides accurate guidance for the relative speed of the left and right dies. Most of the pins are fixed on the lower die seat and cooperate with the guide posts of the lower die seat. The guide pin is properly guided to the pin part of the male die of a high precision punch in the raw material hole. This slide is used to correctly guide the mold of the mold, the application of the correct guide stamping out of the mold. The guide plate of the material guide plate (belt and roll) is a guide part of the cavity. The column sleeve is the guide rod, and the guide sleeve is arranged in the middle of the dragging die.

The stamping die of high speed fine high speed punch machine is installed in the whole process of press stamping and the processing process of machine C-type high speed punch equipment accessories, which is composed of two parts. The punch is a convex product piece that immediately passes the punch. Mold cavity is based on the punch and punching machine immediately produced by the concave working component. Accessories lithium battery protection plate is to avoid fingers or dirty things into the stamping die risk area of the plate. Stripper plate (ring) is the overflow component of the stamping raw material or the process management raw material of the stamping die. It is the most famous adhesive in the drawing die and pin. Drawbead is a drawing die or drawing die used to manipulate the bead process of freight logistics. The drawbead can be part of the mold or adhesive structure and can be placed in different locations of the mold or adhesive. The cross section of the compression beam is a unique rectangular frame drawbar. See the mold. The board is used to connect the control module on the plane diagram and support the stamping raw materials of the column with a small manual punch press. The mould is made of two or more stations, and the raw materials are sent to one station together with the schedule of the news report.