In the application of mould, the setting and application of mould setting conditions as an example, the setting and drying of mould setting conditions parameters, for high-speed machining machine productivity and quality reliability has a vital effect.

Under the condition that the special model private aircraft cannot be satisfied, the one-to-one correspondence between the mold and the high-speed punch frame mold conditions can well consider the provisions of the condition parameters, that is, one mold one machine one condition parameter, and one mold N machine has N condition parameters.

Concrete steps for, according to mould the overall requirements, suitable for cargo capacity is suitable for the high speed punch structure, according to mould standard deviation parameter setting and adjustment, do mould adjust the original ideal, and follow up production quality, do the ability to work process meets the requirements, is defined as the mold in the device table fixed parameter, afterwards, in accordance with the fixed parameters in mold manufacture, condition of dry solid steady purpose.

In the same way, in other machines and equipment to carry out the condition setting of the die, and then produce a series of high precision punch fixed fixed frame die condition parameters, this condition parameters for productivity and quality stability to show the most fundamental to ensure.

A, in some cases, the guide rail slider small precision punching machine to terminate the dead point, make have to tear open outfit on mould and lower mould clamping, then on the mold on the pin from the installation on the slide groove on unloaded, will die under the pin away from the work station of the slide rail slot, then improve the guide rail slider;

B. Press and hold the emergency stop switch, turn off the power supply and pneumatic valve of the production line, open the air discharge gate valve of the air compressor storage tank, and release the residual air compression inside;

C. The upper and lower molds that have already been closed and must be dismantled and assembled are gradually withdrawn from the operation table and pushed down to the double tilt plate for dismantling the molds;

D. Lift out the upper mold and lower mold that must be disassembled by driving;