1, punch automatic automatic feeding device, if it is a sheet of automatic suction manipulator device, ultra-high speed punch in the specific use of such a problem will appear:

Cutting some good pieces of pieces of metal buttress material piled up together, it also has some oil, usually relatively tight adhesion, in into the automatic suction manipulator device manufacturing, everything is a piece of a normal pumping of stamping die, but usually produces a suck up the two pieces together or a large number of copies sent to the press, it is very easy to cause the hardware mold mold destroyed threat.

2, looking for an electronic device in the feeding process of double zhang inspection panel, a sensor head installed point on expected after the probe of magnetic head, there are two pieces or shipping with above two pieces of raw materials, the detector will immediately check out, output signal, alarm and alarm signal after high-speed punching machine factory of PLC control system software, to be able to get a stoppage in transit or after mechanical equipment control system, the abnormal several pieces of raw materials to clear out, so it is reasonable to maintain the production line equipment, especially to prevent the destruction of the metal mould.

3, automatic feeding device and high speed fine punch network, must be at least two signals: feeding, pressure release (two signals from the punch camshaft)

According to the set feeding length, the feeding device PLC outputs the signal to the 65 ton high-speed punch servo amplifier after receiving the feeding signal. The servo amplifier controls the motor operation, and the myopia of the motor operation is fed back to the servo amplifier by the opinions of the servo motor, and the two cooperate with each other to set the feeding length transmission.

When the punch arrives at the dead point, the feeding machine PLC receives the release pressure signal, then the PLC outputs a signal drive relay posture, the relay controls the feeding machine cylinder, cylinder piston rod posture, so that the feeding organization on the roller loose.

4. Automatic feeding device is the most basic provision of automation technology for stamping parts processing, and it is also the basic premise for completing multi-procedure stamping dies on a set of molds. Automatic feeding device each time into the cutting distance known as the feeding distance, feeding distance can be based on the appearance of metal stamping parts specifications and stamping die design must be clear design scheme.