1, every day after work to do a good job in the cleaning work. Water should be added to the air compressor and air compressor storage tank every day. Unsalted butter should be added to the feeder once a month to maintain the stable wettability of 25T high speed punch. Monthly maintenance of three components.

2, lubrication pump high-speed small punch in the work of all normal, steam pressure power switch function;

3. Gas system software can change pressure, overpass and feed oil;

4. The upper and lower limits of the slider can be adjusted normally;

5. Checking and maintenance of balanced cylinder position of high speed, fine and high speed punch press;

6. The wetting points at each position of the transmission device are filled with vegetable grease;

7, clutch and brake pedal part of the gap to determine, abnormal sound abnormal inspection and maintenance;

8. Checking and maintenance of the circuit of household appliances and the route of the actual operating panel, and the safety circuit;

9. Disassemble the top cover of the transmission gearbox, check the journal and noise, check and maintain the oil quantity;

10, slider general process (tee, cover. Disassemble and dissolve the overload hydraulic cylinder, worm gear and vortex rod, clean and maintain, adjust the gap and wear surface, check the skeleton seal and wipe the grease again.

11. Disassemble, dissolve, clean and check the wear surface of the die cushion, wipe the lubricating grease again, and then assemble for trial operation.

12. Check the CAM controller: the camshaft plate and shaft shall not experience large backlash, shall not have intermittent contact, shall not have anchor bolts,

Key loose condition, the roller and shaft of the toggle switch should not be worn out too much;

13. Check the control relay of automatic high-speed punch press: there should be no bad contact, sound, or jamming during fitness exercise;

14, check the actual operation keys and power switch: prevent dust and oil stains, fitness exercise convenient, stable, accurate positioning reliable;

15, check the relay of the clutch and braking system: the electromagnetic coil should be tightened to prevent shaking;

16, remove the waste in the whole process of maintenance.