1. High-speed punch manufacturers should properly apply the safety maintenance and operation equipment on machinery and equipment, and can not be dismantled at will.

2, check the punch transmission system, connection, moistening and other positions and safety protection safety device is not all normal, mold shell screw must be firm, do not move.

3, punch in the work before the need to make the aviation parts turn for 2-3 minutes, check the foot brake and other control equipment coordination ability, to determine everything is normal before the application, can not be run with fault.

4, before driving should pay attention to moistening, take out all floating objects on the surface of the bed.

5. When the punch is moving or in operation, the operator should stand up properly, the hand and the top of the head should maintain a certain distance with the Dobby high-speed punch, and always pay attention to the position of the punching needle, and it is strictly prohibited to chat with others.

6, punching or vex short product workpiece, the use of professional special tools, not at your disposal immediately feed or pick up goods.

7. The place around the punch should be kept clean and the road should be unobstructed. It is strictly prohibited to pile up goods and other items in the risk area.

8. Overload stamping die is strictly prohibited. Operators should strictly abide by this specification during production and processing.

9. Check the standard pressure mark before working, and do not drive if it does not reach the required working pressure value.

10. Before starting, open the blowdown valve of the oil and gas separator to release oil accumulation and water storage, and remove and replace the filter system of the oil and gas separator on time according to the detailed situation. Check the amount of remaining oil in pneumatic triplets to maintain adequate storage.

11. The key of the mold shell is firm, the upper and upper die are aligned, to ensure the proper part, and the punching press is tested by hand (open in the air) to ensure that the mold shell is working in good condition.

12, the production workshop has full-time personnel program writing, full-time personnel check, check the process before typing the automatic switch knob is not placed in the appropriate place. Single flush, the hands and feet are prohibited on the hands and feet brake, be sure to flush a move (step), resolutely put an end to safety accidents.

13. When making or veiling long body parts, there should be no safety bracket or other safety precautions to prevent digging.