1, the bed body part: the bed body and the United States high-speed punch operation table built into one of the cast iron.

2. Clutch: when the press does not work, the camshaft of the manipulator is pushing and blocking the tail end of the key, so that part of the crescent fox in its work is thoroughly sunk in the crankshaft semicircular tank. At this time, the crankshaft high speed, the slider stops at the top dead center; When the press is working, the camshaft of the manipulator turns to an Angle of view, and the end of the key is forbidden to open. By the effect of playing yellow, the key rotates 45°. During the work, part of the back goes into one of the three round grooves in the middle sleeve at will.

3, slide block: in the slide block, there is a pressure stepping commercial safety device under the ball bowl that is touched with the screw ball cage of the adjusting extruder, which ensures that the press is not easy to be destroyed when it is overweight. Open the front face square cover to change the commercial safety device.

4. Brake system belt: the left side of the crankshaft is equipped with an axial force type brake system belt. When the clutch is loose, it can get rid of the inertia force of repeated motion of the slider of the high-speed punch press imported from Germany to ensure that the crankshaft stops at the top dead point.

5, manipulator: manipulator manipulator manipulator clutch fusion and separated out of the organization. By changing the joint position of the support rod of the manipulator, two postures can be obtained: one stroke arrangement and continuous stroke arrangement.